Code-3 Visor Flip Light Manuel d'utilisateur télécharger pdf (Page 4)

LED module housings may become hot with extended use. Allow modules to cool complete-

ly before attempting to remove.

WARNING!

TROUBLESHOOTING

Problem Probable Cause Remedy

Lighthead does not activate a. No power to unit a. Check wire for loose connection

b. Power input wire reversed b. Reverse power wires

c. Damaged or shortaged cabling c. Check cables for damage

d. Defective lighthead d. Replace lighthead module

Lighthead is constantly ON a. Control wire permanently

grounded or shorted to GND

a. Avoid permanent grounding of

control wire

Setting the Flash Pattern:

Push and hold either of the white oblong buttons in the center of the Visor Light as follows

- Less than 1 second for the NEXT pattern

- 1 to 3 seconds for the PREVIOUS pattern

- 3 to 5 seconds for the P13 QUAD FLASH 75FPM PHASE 1 pattern

- Greater than 5 seconds to TURN OFF the LED Light Head

Synchronization:

The (2) Par 36 lightheads in the LED Visor Light are synchronized from the factory. To congure the two light-

heads to alternate their patterns, advance the pattern of either beacon to the Phase 2 mode of the current pat-

tern. Please note that some ash patterns do no synchronize well together due to the timing required between

ash sequences. The user should visually conrm that the selected ash patterns are providing the desired

result.

Maintenance:

The LED Visor Light with PAR36 Modules is designed to be maintenance free. Refer to the guide below for

help with troubleshooting. Should the unit be diagnosed as malfunctioning, remove unit and replace with a new

module.

1 2 3 4 5 6 7 8

Pas de commentaire

Code-3 Visor Flip Light Manuel d'utilisateur Page 4