Code-3 2100 Manuel d'utilisateur télécharger pdf (Page 8)

LED DIRECTIONAL MODULES

In addition to the 360 warning modules the lightbar may be equipped with a number of single head directional warning LED

modules. These modules are available in either the LED X™ ( 1" X 4" ) ,6-LED OPTIX™ ( 1" X 6" ), 3-LED OPTIX (1"x4"), 33

OPTIX (two 3-Up heads using one 6-LED OPTIX optic) or LC-LED directional modules in stationary and flashing versions ( see

figure 6). The stationary versions can be flashed by connecting the module(s) to any flasher that does not require ground

through the load (example: Code 3® 700 series relay flasher). The flashing modules will have "Cycleflash" as the standard

pattern. The OPTIX and LEDX flash pattern can be changed by shorting the 2-pin header, J1 as shown in Figure 7,

momentarily then releasing. Table 2 shows the available patterns and the order when stepping through patterns. The module

can be reset to "Cycleflash" by shorting the header for greater than 5 seconds and releasing. The LC-LED Modules flash

patterns can be changed as described on page 9.

Operating Specifications for directional module:

Operating Voltage: 10-16 VDC, Reverse Polarity Protection

Current Draw : Flashing Module

Red/Amber - .25A avg @ 12.8 Volts

Blue/White - .4A avg @ 12.8 Volts

Steady Burn Module

Red/Amber - .5A avg @ 12.8 Volts

Blue/White - .8A avg @ 12.8 Volts

Available Colors - Red , Blue, Amber, and White

BLACK

RED

T01215

T00243

FIGURE 6

BLACK

RED

T01215

T00243

LED X™ ( 1" X 4" ) LC-LED (1"x4")

MODULES

OPTIX ( 1" X 6" )

MODULES

DIMMING

WIRES

DIMMING

WIRES

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Code-3 2100 Manuel d'utilisateur Page 8