Code-3 2100 Manuel d'utilisateur télécharger pdf (Page 11)

FIGURE 10

If attempting to clean the reflector, use only a mild glass cleaner and a very soft cloth. Do not attempt to use any wax type

products as these will burn onto the reflector.

Remove the reflector assembly by removing the appropriate fasteners, then remove the snap-on filter if necessary. In most

cases, these lamps will be a bayonet style, so simply push in and turn counterclockwise to remove.

FIGURE 11

MR11 Style Assembly

For MR11 style takedown or alley light assemblies refer to Figure 11 for lamp replacement. Remove the

lamp assembly by removing the appropriate fasteners, remove fasteners sandwiching MR11 in bracket, and

remove lamp. Replace the lamp and reassemble.

Caution: Be sure to replace the heat shield gasket with the foil side up when reinstalling

the takedown assemblies. Damage could occur without this gasket.

ALLEY ASSEMBLY for use with OPTIX™

ALLEY ASSEMBLY for use with LED X™

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Code-3 2100 Manuel d'utilisateur Page 11