Code-3 PSE690 Remote Strobe Power Supply Manuel d'utilisateur Page 1

Read all instructions and warnings before installing and using.INSTALLER: This manual must be delivered to the end user of this equipment.INSTALLATI

NOTES10

NOTES11

Code 3 is a registered trademark of Public Safety Equipment, Inc.CycleFlash is a trademark of Public Safety Equipment, Inc.Public Safety Equipment (U

2WARNING!IntroductionThe PSE-690 Series Remote Strobe Power Supply represents the latest in state-of-the-art strobe warningtechnology. The latest in M

Unpacking and Pre-installationRemove the power supply from the box and examine the unit for any transit damage. Report any damage to thecarrier immedi

4The Model PSE-690 Strobe Power Supply is NOT waterproof and should be located in anarea protected from the weather and water.WARNING!Installation and

5FIGURE BFIGURE CNOTE: IT IS IMPORTANT TO FOLLOW THE CORRECT COLOR CODEWHEN INSERTING THE PINS INTO THE AMP 3 PIN CONNECTORS.4. Connect the cables to

6FIGURE D1. Connect the Control wires from the Power/Control wire harness assembly to a switch or switches. To selectone of the 8 different flash func

7FIGURE EFOR NFPA COMPLIANT INSTALLATION, SELECT QUADOR FIVE FLASH MODESTo have the ability to select the 8 available patterns, connect each control w

TROUBLESHOOTING GUIDE8TroubleshootingNOTE: DO NOT TAMPER WITH THE POWER SUPPLY. THIS UNIT IS SOLD AS A COMPLETEMODULE, AND IS NOT DESIGNED FOR FIELD R

9NOTES