Code-3 OsciLaser Retrofit Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Code-3 OsciLaser Retrofit. Code 3 OsciLaser Retrofit User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Contents:
Installation & Mounting ............................................ 2-3
Product Returns ....................................................... 4
OSCILASER
RETROFIT KIT
INSTALLATION
& OPERATION
MANUAL
Read all instructions and warnings before installing and using.
INSTALLER: This manual must be delivered to the end user of this equipment.
IMPORTANT:
OLKIT
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - RETROFIT KIT

Contents:Installation & Mounting ... 2-3Product Returns ...

Page 2

2Remove the reflector fromcarriage (save the 2 1/4 inchhex screws) and discard.Cut gray ground wireand discard.Desolder both wires atmotor, discard gr

Page 3

3Install new reflector. Attachground jumper and positivefeed wire.Detail of solder joint showingdirection of wires.Note gap between ground wireand p

Page 4 - PRODUCT RETURNS

LP6000 and XL5000 are trademarks and ArrowStik is a registered trademark of Code 3, Inc. a subsidiary of PublicSafety Equipment, Inc.3M is a registere

Commentaires sur ces manuels

Pas de commentaire