Code-3 Hide-A-Way Manuel d'utilisateur télécharger pdf (Page 2)

Introduction

The Hide-A-Way Strobe Light Heads are designed as auxiliary lights for the emergency vehicle market. The

light heads can be used with either the

CODE 3

PSE Amber

, 2 head or 4 head Strobe Power Supplies

by using the optional cable assemblies. Use of any other power supply may cause shortened service life of

the strobe tube.

Consisting only of a clear or colored strobe tube assembly, flange bracket, mounting fasteners and a gasket,

the Hide-A-Way Strobe is easy to install. The design allows the user to customize the lighting system without

changing the vehicles appearance. For installations or replacements after 1/1/2005, the new grommet stlye

tube is supplied. This eliminates the need of the flange and gasket.

Unpacking And Pre-Installation

Carefully remove the light head from its protective packaging. Inspect the unit for transit damage (broken

strobe tube, etc). Report any damage to the carrier and keep the shipping carton. Verify that two #6 x 1/2”

screws per lighthead are included (flange mount tubes only). The optional three wire cable comes in a 15, 20

or 25 foot length. Both ends of the cable have Amp #60619-0 sockets attached to each wire. The cable comes

with a parts bag consisting of 2 AMP #1-480303-0 Mate-N-Lok socket housings and 1 #8 noninsulated ring

terminal. Verify that these items are also included.

The use of this or any warning device does not insure that all drivers can or will observe or

react to an emergency warning signal. Never take the right-of-way for granted. It is your

responsibility to be sure you can proceed safely before entering an intersection, driving

against traffic, responding at a high rate of speed, or walking on or around traffic lanes.

The effectiveness of this warning device is highly dependent upon correct mounting and

wiring. Read and follow the manufacturer’s instructions before installing or using this

device. The vehicle operator should insure daily that all features of the device operate

correctly. In use, the vehicle operator should insure the projection of the warning signal is

not blocked by vehicle components (i.e.: open trunks or compartment doors), people,

vehicles, or other obstructions.

This equipment is intended for use by authorized personnel only. It is the user’s responsi-

bility to understand and obey all laws regarding emergency warning devices. The user

should check all applicable city, state and federal laws and regulations.

Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of

this warning device.

Proper installation is vital to the performance of this warning device and the safe operation

of the emergency vehicle. It is important to recognize that the operator of the emergency

vehicle is under psychological and physiological stress caused by the emergency situation.

The warning device should be installed in such a manner as to: A) Not reduce the output

performance of the system, B) Place the controls within convenient reach of the operator

so that he can operate the system without losing eye contact with the roadway.

Emergency warning devices often require high electrical voltages and/or currents. Properly

protect and use caution around live electrical connections. Grounding or shorting of

electrical connections can cause high current arcing, which can cause personal injury and/

or severe vehicle damage, including fire. Do not touch the strobe light tubes, the strobe

light head assemblies or the strobe power supply while the system is in operation. Wait 10

minutes after turning off the power from system before touching any internal components.

PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER

USE OF EMERGENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY

OF EMERGENCY PERSONNEL AND THE PUBLIC.

WARNING!

The inherent variability of where the user mounts the strobe lamp unit in the reflector

assembly and the resultant non-optimal use of the reflector optics preclude certification to

the requirements of Ca. Title XIII, SAE, AAMVA, GSA, KKK, 1822C or may invalidate DOT/

SAE certification of OEM lighting. The units are intended for SECONDARY warning only

and are intended for USE IN CONJUNCTION with an approved PRIMARY warning light

system.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Philips RC136/17 Manuel de l'utilisateur (16 pages)

marque: Philips | Catégorie: No info | Taille: 0.57 MB |

Table des matières

Directions for Use

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Table of Contents

Package Contents

Connections

Remote Control Set-Up

Satellite Functions

TV Functions

VCR/DVD Functions

• If the 3-digit code is not

Universal Remote Codes

Quasar .003, 048, 064, 085

Shintom 003, 053, 058, 094

Limited Warranty

Plus de produits et de manuels pour Non Philips

Modèles	Type de document
SBC HC630	Manuel de l'utilisateur Philips SBC HC630 User's Manual, 2 pages
F-2200	Manuel de l'utilisateur Philips F-2200 User's Manual, 22 pages
AZ6840	Manuel de l'utilisateur Philips AZ6840 User's Manual, 2 pages
DVP3110/93	Manuel de l'utilisateur Philips DVP3110/93 User manual, 2 pages
FW338C	Manuel de l'utilisateur Philips FW338C User's Manual, 30 pages
AZ 8048	Manuel de l'utilisateur Philips AZ 8048 User's Manual, 13 pages
22ER9142	Manuel de l'utilisateur Philips 22ER9142 User's Manual, 17 pages
Halogen P-8181-C	Manuel de l'utilisateur Philips Halogen P-8181-C User's Manual, 2 pages
DCK3020/00	Manuel de l'utilisateur Philips DCK3020/00 Benutzerhandbuch, 2 pages
MCD709/93	Manuel de l'utilisateur Philips MCD709/93 User's Manual, 4 pages
GOGEAR SA2946	Manuel de l'utilisateur Philips GOGEAR SA2946 User's Manual, 31 pages
VCM8936	Manuel de l'utilisateur Philips VCM8936 User's Manual, 15 pages
DVP3355V/F7	Guide de démarrage rapide Philips DVP3355V/F7 Manual de usuario, 2 pages
SGC5101BD/17	Manuel de l'utilisateur Philips SGC5101BD/27 Manuale utente, 6 pages
VR650	Manuel de l'utilisateur Philips VR650 User's Manual, 30 pages
G110	Manuel de l'utilisateur Philips G110 User's Manual, 17 pages
AX5200/00C	Manuel de l'utilisateur Philips AX5200/00C User's Manual, 2 pages
AZ 8102	Manuel de l'utilisateur Philips AZ 8102 User's Manual, 13 pages
PL-L	Manuel de l'utilisateur Philips PL-L User's Manual, 2 pages
AZ 7394	Manuel de l'utilisateur Philips AZ 7394 User's Manual, 23 pages