Code-3 930 and 940 Flashers Manuel d'utilisateur télécharger pdf

INSTALLATION

& OPERATION

MANUAL

MODELS 930 & 940

FLASHERS

Contents:

Introduction......................................................... 2

Unpacking & Pre-Installation .............................. 2

Installation & Mounting ....................................... 3

Terminal Functions............................................. 3

Flasher Installation ............................................. 4

Testing the Flasher............................................. 6

Warranty ............................................................. 8

IMPORTANT:

MODELS 930 & 940 FLASHERS

Read all instructions and warnings before installing and using.

INSTALLER: This manual must be delivered to the end user of this equipment.

1 2 3 4 5 6 7 8

1INSTALLATION& OPERATIONMANUALMODELS 930 & 940FLASHERSContents:Introduction... 2Unpackin

2IntroductionThe Code 3® Model 930 and 940 flashers are postiive output solid state flashers. Both models aredesigned for use inside light bars and o

3Installation & MountingMounting MethodsThe units can be mounted using either the mounting tabs located at each end of the unit or the mountinghol

4FIGURE 1: WIRING DIAGRAM FOR 930LIGHT BAR FLASHER INSTALLATIONTerminal 10 - Output 2: 8 amps Maximum.Terminal 11- To Battery Negative (-). Provides

Page 5

5NOTE: For continued Alley light flash while in low beam, do not connect Terminal 1.8) Connect the negative (-) post of the battery, or other good gr

6Testing the FlasherTesting the 930 Flasher1) Install the 20 amp. fuse in the in-line fuse holder.2) Turn ON the switch connected to terminal 2. The

Page 7

7NOTES

Public Safety Equipment, Inc.10986 N. Warson RoadSt. Louis, Missouri 63114-2029USAPh. (314) 426-2700 Fax (314) 426-1337www.code3pse.comRevision 0, 5

Pas de commentaire

Code-3 930 and 940 Flashers Manuel d'utilisateur