Code-3 Sprinter 24 Volt Manuel d'utilisateur télécharger pdf (Page 5)

3. To install the positive and negative power wires, strip 1/4” of insulation from the end of the wires, and install the blade

connectors onto the ends of the appropriate wires. The “+24V” positions may be connected either directly to a +24V

source (such as a battery), or through a switch (such as an ignition switch). (See proper fusing requirements on page

6 prior to making any wire connections to battery or ignition switch)

Figure 1 - Wiring Diagram

10 AMP

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Code-3 Sprinter 24 Volt Manuel d'utilisateur Page 5