Code-3 H2Covert Siren Manuel d'utilisateur télécharger pdf (Page 5)

5. To install the positive and negative power wires, strip 1/4” of insulation from the end of the wires, insert the red wire into

the left port of the two-position, pluggable connector (color green), which corresponds to the “+12V” position, and the

black wire into the right port, which corresponds to the “NEG” position, and tighten the screws. The “+12V” position may

be connected either directly to a +12V source (such as a battery), or through a switch (such as an ignition switch).

Figure 1 - Wiring Diagram

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Code-3 H2Covert Siren Manuel d'utilisateur Page 5