Code-3 C3100 Series Speaker Manuel d'utilisateur télécharger pdf (Page 3)

Selecting a Mounting

Location: The mounting

location should not only be

as flat as possible but also,

allow the siren to project its

tone parallel to the road.

For detailed information on

mounting locations for

certain specific vehicles,

see the following pages.

Installation: Position the

bracket onto the desired

mounting area and mark

the centers of the 4

mounting holes using the bracket as a template.

Now in the center of each of the 4 holes you marked, drill a 1/8-inch pilot

hole into the mounting surface for each of the 4 screws then enlarge the

pilot holes with a 9/32-inch drill. If you can get access to the other side of

the mounting area, and it is not too thick, you may want to substitute the 4

mounting screws with nuts, bolts and washers (customer supplied) of

comparable strength and size.

Fig 1

Fig 2, 8 possible mounting positions for the Universal bracket. It is

absolutely essential that the speaker be mounted so that the wires

exit at the the bottom (toward the ground). Improper mounting will

cause damage to your C3100 Speaker and void the warranty

1 2 3 4 5 6 7 8

Pas de commentaire

Code-3 C3100 Series Speaker Manuel d'utilisateur Page 3